Zipper puller is a frequent situation in life, so how to get it back when the zipper puller is lost.
How do I put the zipper back when it falls off?
1. After the lighter is cut, the lighter burns off the edge to prevent it from falling off.
2. Pull the zipper puller into the teeth in the upward direction of the pull teeth. Pull the ends of the tape (arrows) together and out as shown. The zipper will follow the tension of the tape. into the teeth.
3. After pulling out the fabric, the slider is loaded.
4. Pull out the extra teeth with diagonal pliers.
5. Install up and down.Brass Burnish Zipper
The above is a detailed description of how zipper manufacturers pay attention to the wear and tear of the zipper head.Brass Burnish Zipper
Handling tips when zipping into clothing.
1.You may experience a situation where the zipper gets caught in the fabric of the replica garment when the zipper is pulled and you are unable to move or move the zipper. Do not pull hard at this point, or it will get tighter. The fabric stuck in the slider should be slowly pulled out, then the slider should be pulled back to its original position and slowly pulled up. Be patient and deal with it!
2.When you use zipper techniques, you should pay attention to zippers such as belly breaks, removal of teeth and skewing. If the zipper is loose and has teeth, you can use a small hammer to tap the zipper head a few times to make the upper and lower teeth bite tightly, and you will not be able to remove the teeth again.
3.Don't fill up your various bags, pockets or purses with zippers. When pulling the zipper, first align the teeth on both sides, then pinch the zipper head, and gently pull forward along the track without pulling hard.Brass Burnish Zipper
Post time: Aug-15-2023