This knotted flower-like look is stunning and gives the packaging a fresh spring/summer vibe.
Difficulty of Operation: Intermediate Knot Size: 15cm
To make this ribbon bow wrap please have:
✧91cm long, 40mm wide clip wire ribbon
✧69cm long, 16mm wide clip wire ribbon
✧12. 5cm long, 40mm wide metal silk ribbon, knotted
✧ Branding brush, lighter or hemming liquid
✧2 duckbill clips
✧20cm long metal wire with a diameter of 0.4mm
✧Hot melt glue gun and glue stick
1. Cut the 40mm wide bottom ribbon into 6 15cm strips and the 16mm top ribbon into 6 11cm strips. Trim the ends with an inverted V cut and seal the edges.
2. Fold all the straps in half and find the center. Unfold one of the organza silk ribbon and pinch the middle vertically.
3. Take another 2 bottom ribbons, do the same, and put them together with the 1st bottom ribbon. Secure the 3 ribbons with a clip. Repeat the above steps and you will get 2 bundles of fixed bottom ribbons of 3 each.
4. Remove the clips on the 2 bundles of ribbons, pinch the 6 ribbons together, tie the middle with a metal wire with a diameter of 0.4mm, and the ends of the wire stick out from the top of the ribbon knot.
5. The top-level belt knot is also made according to steps 2~4, but does not need to be tied with metal wires. Place the top ribbon knot on top of the bottom ribbon knot, and tie the two together with the metal thread sticking out of the bottom ribbon knot. Wrap the wire around the opposite side of the ribbon knot and twist to secure.
6. Glue the knotted center ribbon to the middle of the knot and wrap its tail around the center of the pinwheel knot. Trim the tail well of the center knot as needed and glue it to the back of the pinwheel knot. Adjust the top and bottom steps of the pinwheel knot to make it symmetrical.
Post time: Aug-11-2022