In order to give full play to the practical or decorative functions of Alloy Button, it is necessary to determine a reasonable binding method according to the different characteristics of various buttons and the actual fabric characteristics. The fabric at the binding button must have sufficient fastness and thickness to avoid damage to the fabric or the button falling off. The problems caused by the thickness of the fabric and their solutions are as follows.
1. The fabric is too thin
For some garments such as knitting and silk, due to the thinner fabric itself and the lower strength of the fabric, after the snap buttons are bound, the fabric is likely to be damaged because the pulling force of the buttons exceeds the tensile force that the fabric can bear.
Solution:
Choose a product with a smaller separation force
Add adhesive interlining, plastic gasket, etc. between the cloth layers at the binding to increase the thickness and strength of the cloth layers
2. The fabric is too thick
Each button has its own suitable binding fabric thickness range. If the fabric is too thick, it may cause fabric damage due to too much binding pressure, or Plastic Pearl Button damage and deformation. In addition, for fabrics that are super thick and have too many folded layers at the binding, it is difficult to penetrate the fabric solely by external force during binding, and buckles may drop due to weak binding.
Solution:
In clothing design, reduce the thickness by reducing the number of fabric layers
For specific fabric thickness, use the extended button foot. Therefore, when a garment factory orders buttons, it is best to know the thickness of the fabric in advance and communicate with the button manufacturer so that the button manufacturer can provide suitable buttons.
Before button binding, the fabric is perforated at the binding point, and then the button is bound
3. Uneven fabric thickness
When the same kind of buttons are bound against different positions of a garment, if the number of fabric layers differs greatly, it will cause two situations: first, if you want to take into account the thinner parts of the fabric, you must increase the binding pressure, but there will be It may damage the fabric of the thicker part or deform the Gold Brass Button: on the contrary, if the thicker part is considered, the button will turn, loosen or drop due to insufficient pressure on the thinner part of the fabric.
Solution:
Avoid binding on the seam, try to bind on the uniform part of the fabric
Button binding by process
Post time: Jan-03-2023